Low cost high quality anti static flooring wood cores raised floor

Low cost high quality anti static flooring wood cores raised floor

Product Description:

The woodcore anti-static raised access floor system is made of high density particle board. Bottom is galvanized steel sheet / aluminum sheet. Edge is 4 pcs black PVC trim along each side of the panel. Cover is HPL/ PVC or others according to the customers' requirement. This type flooring is as same as imported floor. This product technical performance is equivalent to the imported flooring products with a high loading capacity, high-wear-resistant factor, light weight, low environmental pollution, foot feeling well, also have soundproof, shockproof, fouling resistance, corrosion resistance, high wear resistance, effective pavement, long using life, etc.

Performance Select Chart:

Our Service:

Changzhou Basic Company uphold the principle of "a full range,high quality fast"service standards, customer satisfaction as the goal, to the public commitment.

After-sales Service Letter of Commitment:

   User quality problems arise in the normal use condition, both steel cementitious bare finish floor and the ceramic raised floor are guaranteed to keep in good repair for 5 years.If quality problems happen in guarantee period, our company will maintain for free.Additionally, our company provides technical support and fittings for life. After-sales service isn’t restricted by time and we will assign technical personnel to solve your problems immediately after receiving telephone or mails and hear feedback idea of users and deal with them in time. If you caught in some problems when using our products, welcome to contact us at any time.

Installation:

1.At first, cleaning the ground.

2. Observe the layout of room, install infrared paralleled scanner, mark paralleled line on half waist of wall, then find lowest and highest point, calculate average value from ground to floor surface(this average value equals to owner’s required installation height),calculate and adjust the pedestal height

3.Choose a corner as start point, find a parallel on wall, tie two paralleled wax wire 595mm from wall, the wax wires are hard to brake and extend, two wires must be vertically distributed.

4.When pulling the paralleled line, screw the four pedestals. After confirming the height and placing the first floor, stringers and pedestals must be fix with screws, use level bar to adjust floor, at last, lock nuts on the pedestals.

5.When the first floor is adjusted paralleled, vertically place two lines of floors in the direction of wax lines. Note: black glued edges between floors must be aligned and straight.

6.After vertically placing two rows of floors, find a direction,(cannot be vertically placed), paralleled place row by till the last row. Note: each edge should remain one row for final cutting and placing, when paving, floors cannot be treaded which may affect flatness .

7.After placing last row, iron angles in each corner should be firstly fixed, then cut all-round floor. Noted: iron angle should be paralleled to installed floor. backing if iron angle should possess a support(flitch or angle bar).

8.After fixing iron angle, exercisely

measure the size of floor, hen cut and places it. If need placing plug, se cutting machine to open holes as per actual dimension.

9.After placing floor, heck on time, Adjust the parts which are not flat. Finally fill in gap when cutting with glass cement.

10.If the temperature difference between day and night at construction site is big,(eg. high altitude, temperate area or arctic area),all the edges should remain 3mm gap.

Packaging & Shipping:

The woodcore raised floor with hpl or pvc is consist of panel, pedestal, stringer and screws. Usually the panels are packed by wooden pallet, the accessories are packed by cartons.

  The woodcore raised floor with hpl or pvc belong to heavy load products, so we always choose 20 feet container,it can ship 500 sqms per container. 

Company Information:

 Changzhou Basic Computer Room Equipment.,Ltd is established in 2016.We are the manufacturer factory in Changzhou City,Jiangsu,China.We have full steel anti-static cementitious raised floor,full steel OA bare finish access floor, anti-static perforated raised floor,anti-static ceramic laminated raised floor,electrical floor box outlet and grommet,etc. We can also help you to look for other products from China as well if possible.

 Quality First, Service First ,Price Best ,welcome to contact us .

FAQ: